dichtol HS-EP fast

Application
Weigh out the two material components precisely in a clean container and mix them together. The correct mixing ratio is essential. Alternatively, the matching set containers supplied can be mixed together completely. Mix very thoroughly. The object temperature should not exceed the application temperature of +100 °C.

Painting & spraying
Apply dichtol crosswise in 4 working steps at intervals of approx. 1 minute. Keep the surface moist for at least 5 minutes to ensure sufficient time for deep penetration.

Injecting & filling
Fill the space to be sealed (e.g. blind hole, threaded hole, cooling channel, etc.) with dichtol and leave to act for at least 5 minutes. Then pour off excess material if necessary.

Diving
Immerse the component to be treated in dichtol and remove after a contact time of at least 5 minutes. Please ensure that the component drips off properly. It is recommended to move the component while dripping to prevent deposits of dichtol from forming in undercuts or cavities.

Curing
Curing takes place under room conditions through chemical cross-linking. The curing time can be found in the table ‘Product data cured’. Temperature and substrate properties can significantly influence the duration. The curing time can be shortened by applying heat. Please note that 100 °C must not be exceeded.