310P

Storage / Shelf life Store in the original, unopened container in a dry, cool and frost-free place (+5°C to +20°C). Shelf life 2 years. Protect from direct sunlight. Higher temperatures reduce the shelf life. Preparation of the bonding surface The surfaces to be coated should be roughened considerably to improve adhesion. The roughening depth should be 0.5 mm (Rt = 500μm). The roughening can be produced, for example, using a cutter head with a high feed rate on a milling machine. Surfaces must be clean, dry and free of grease and oil. For cleaning dirty surfaces, we recommend DIAMANT Cleaner #1417 or DIAMANT Cleaning Spray #1534. Surfaces to which DWH should not adhere should be coated with Release Agent #1354 or Release Spray #1355. Mixing procedure To mix DWH 310 FL, add component B completely into the container of component A. Mix intensively using a drill and the DIAMANT mixing propeller (Prod. No. #0789) (max. 250 rpm for approx. 2 minutes). Remove any material adhering to the walls of the container with a spatula and add to the mixture. Mix thoroughly again. Deaerate DWH 310 FL should be poured into a clean container in a long, thin, uninterrupted stream Application description DWH 310 FL can be poured freely flowing into the sufficiently large gap open at the top. Alternatively, DWH 310 FL can be injected through an inlet channel into the prepared, sealed cavity after it has been decanted into a hand cartridge. To avoid air pockets, the cavity is filled from the lowest point. Qualification and service It is recommended that the application is carried out by trained DIAMANT technicians. To ensure the best possible quality and error-free application, we offer the following services: Advice by telephone and / or on site at the construction site Site supervision and monitoring of the work on site Complete execution of the work by our experienced application technicians Further information can be found in the service data sheet.